Nano Science and Technology Institute
Nanotech 2014 Vol. 3
Nanotech 2014 Vol. 3
Nanotechnology 2014: Electronics, Manufacturing, Environment, Energy & Water
 
Chapter 3: Materials for Sustainability & Efficiency
 

High-rate Manufacturing of 3D Products with Micro and Nanostructured Surfaces

Authors:C. Barry, J. Mead
Affilation:University of Massachusetts Lowell, US
Pages:182 - 185
Keywords:injection molding, nanostructured surfaces
Abstract:Injection molding permits the manufacturing of complex three-dimensional products with micro and nanostructured surfaces in less than 30 seconds. Successful high-rate manufacturing of these surfaces depends on understanding the changes required in material selection, tool design and fabrication, and polymer processing parameters. Although temperatures and pressures are greater than with convention injection molded parts, material selection significantly affects the critical processing parameters. Moreover, polymer-tooling interactions, tooling surface roughness, and heat transfer in the tooling used for these surfaces impacts product quality. Finally, material selection and molded-in stress affect interactions with biological species. Selected injection molded products with micro and nanostructured surfaces will be presented.
ISBN:978-1-4822-5830-1
Pages:588
Hardcopy:$209.95
 
Order:Mail/Fax Form
Up
© 2014 Nano Science and Technology Institute. All Rights Reserved.
Terms of Use | Privacy Policy | Contact Us | Site Map