Nano Science and Technology Institute
Nanotech 2012 Vol. 2
Nanotech 2012 Vol. 2
Nanotechnology 2012: Electronics, Devices, Fabrication, MEMS, Fluidics and Computational (Volume 2)
 
Chapter 7: NanoFab: Manufacturing & Instrumentation
 

Efficiency Enhancement of Dye-Sensitized Nanocrystalline Solar Cells Through Fabrication

Authors:A.A. Ilumoka
Affilation:UNIVERSITY OF HARTFORD, US
Pages:546 - 549
Keywords:nanocrystalline, solar cell, fabrication, characterization
Abstract:This paper reports results obtained from the investigation of electrical performance of blueberry-based DSSCs and makes recommendations regarding their fabrication, specifically optimal sintering temperature and optimal sintering time. Electrical characteristics (open circuit voltage, short circuit current, power max and fill factor) of 10mm X 10mm DSSCs under indoor illumination were measured and cell efficiency calculated from ratio of maximum power output to incident luminous power. It was found that DSSCs fabricated at higher sintering temperatures (>500 degrees Celsius) consistently exhibited efficiencies 2-3 times greater than those sintered at lower temperature (<300 degrees). Furthermore sintering times in the 10-12minute range produced the most solar efficient cells.
ISBN:978-1-4665-6275-2
Pages:878
Hardcopy:$209.95
 
Order:Mail/Fax Form
Up
© 2014 Nano Science and Technology Institute. All Rights Reserved.
Terms of Use | Privacy Policy | Contact Us | Site Map