Nano Science and Technology Institute
Nanotech 2009 Vol. 2
Nanotech 2009 Vol. 2
Nanotechnology 2009: Life Sciences, Medicine, Diagnostics, Bio Materials and Composites
Chapter 4: Biosensors and Diagnostics

Carbon Nanotube Array Sensor for MEMS Lab-on-a-chip

Authors:L.B. Joseph, V. Veedu, D. Garmire
Affilation:Oceanit and University of Hawaii, US
Pages:193 - 196
Keywords:carbon nanotubes, MEMS, lab-on-a-chip
Abstract:Lab-on-a-chip devices have the potential to provide point-of-care diagnostics that can save many thousands of lives per year. One of the primary limitations to wide-spread adoption of lab-on-a-chips is the excessive cost of fabrication and integration in high-volume production of these systems. In this paper, we describe a relatively inexpensive, high-volume technique of fabricating well defined patterns of vertically aligned carbon nanotube arrays (VANTAs) using a standard MEMS process, PolyMUMPs, and a single chemical vapor deposition (CVD) step for nanotube growth. VANTA sensor test structures have been fabricated showing vertical growth over 300 microns, minimum wall width under 20 microns, and high conformance to the defined pattern. In the near future these VANTA sensors will be integrated into a single die lab-on-a-chip that includes silicon-based microfluidics. The VANTA sensor test structures fabricated varied device and process parameters to observe differences in VANTA growth patterns. In this paper, the VANTA sensor structures will be geometrically and electrically characterized, and the specific process parameters which influence the VANTA characteristics will be evaluated in detail to determine how future devices can be further integrated into a lab-on-a-chip.
Carbon Nanotube Array Sensor for MEMS Lab-on-a-chipView PDF of paper
Order:Mail/Fax Form
© 2017 Nano Science and Technology Institute. All Rights Reserved.
Terms of Use | Privacy Policy | Contact Us | Site Map